![]() ![]() The diagram below shows a typical application where Ethernet Media Converters connect to Ethernet Switches by way of Multimode fiber and UTP copper cabling. Hence these converters are also usually divided into Fast Ethernet media converte r, Gigabit media converter and 10 Gigabit media converter. Supporting the IEEE 802.3 standard, Ethernet copper-to-fiber media converters are used to provide connectivity for Ethernet, Fast Ethernet, Gigabit and 10 Gigabit Ethernet devices. Ethernet Copper-to-Fiber Media Converters.Copper-to-fiber conversion using media converters enables two network devices with copper ports to be connected over extended distances via fiber optic cabling. Fiber optic connectivity is necessary when the distance between two network devices exceeds the transmission distance of copper cabling. The most common type of media converter is a device that functions as a transceiver, which is used to convert the electrical signal used in copper UTP network cabling into light waves used in fiber optic cabling. Two main kinds of media converters are copper-to-fiber media converter and fiber-to-fiber media converter. There are a wide variety of media converters available that support different network protocols, data rates, cabling and connector types. In a word, as a device to converter one media to another, media converters are really working. Besides, some other converters also convert multi-mode to single-mode, convert analog signals to digital, multiplex several signals over one fiber pair, or perform other signal processing. This enables you the ability extend your Ethernet network beyond the 100-meter limit imposed by copper cable. The most widely used converters are probably the ones used to convert computers UTP Ethernet ports to fiber. Media converters enable you to connect different types of media, such as twisted pair, fiber, and coax, within a network. Media converters are flexible and cost-effective devices for implementing and optimizing fiber links in all types of networks. This article will review the different types of media converters and provide information on the wide variety of applications for media converters. However, if your switch does not have built-in fiber optic ports or does not have enough fiber-optic ports, then a media converter will be needed to convert copper based communications to fiber-optic communications. Systems that require fiber-optic communication can use switches that contain built-in fiber optic ports. These include immunity to noise and further distance capabilities. There is no doubt that Ethernet fiber-optic communications provide many advantages over copper based Ethernet communications.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |